Home › Code lookup › P2144
Powertrain code · Emissions

P2144 Exhaust Gas Recirculation Vent Control Circuit Low

How urgent? Book a check when convenient

What it means

The control circuit for the EGR vent solenoid is reading low voltage. This part vents vacuum from the EGR valve so it can close. A wire shorted to ground or a shorted part is the usual reason.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the EGR vent solenoid wiring for rubbed-through insulation
  2. Measure the EGR vent solenoid resistance and compare with spec

Signs you may notice

  • Check engine light on
  • Possible rough idle if the EGR valve stays open

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonControl wire shorted to ground
  • CommonInternally shorted EGR vent solenoid
  • PossibleDamaged connector
  • PossibleEngine computer driver problem (rare)

Typical repair once the cause is confirmed

Repair any wiring fault first; if the wiring tests good, replace the EGR vent solenoid.

Repair costInsufficient verified pricing for this vehicle and repair
Replace EGR vent solenoid. Prepare an itemized shop request.

Common questions

What does P2144 mean?

The control circuit for the EGR vent solenoid is reading low voltage. This part vents vacuum from the EGR valve so it can close. A wire shorted to ground or a shorted part is the usual reason.

Can I drive with code P2144?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P2144?

Common possibilities to test include: control wire shorted to ground; internally shorted egr vent solenoid; damaged connector; engine computer driver problem (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.