P2145 Exhaust Gas Recirculation Vent Control Circuit High
What it means
The control circuit for the EGR vent solenoid is reading high voltage. This part vents vacuum from the EGR valve so it can close. A wire shorted to power, an open circuit or a failed part is the usual reason.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check the EGR vent solenoid wiring for shorts to other wires
- Measure the EGR vent solenoid resistance and compare with spec
Signs you may notice
- Check engine light on
- Possible rough idle if the EGR valve stays open
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailed EGR vent solenoid
- CommonControl wire shorted to a power source
- PossibleOpen circuit or corroded connector
- PossibleEngine computer driver problem (rare)
Typical repair once the cause is confirmed
Repair any wiring fault first; if the wiring tests good, replace the EGR vent solenoid.
Common questions
What does P2145 mean?
The control circuit for the EGR vent solenoid is reading high voltage. This part vents vacuum from the EGR valve so it can close. A wire shorted to power, an open circuit or a failed part is the usual reason.
Can I drive with code P2145?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P2145?
Common possibilities to test include: failed egr vent solenoid; control wire shorted to a power source; open circuit or corroded connector; engine computer driver problem (rare). A shop should confirm the cause before replacing parts.