P2171 Exhaust Pressure Regulator Vent Solenoid Control Circuit High
What it means
The control circuit for the exhaust pressure regulator vent solenoid is reading high voltage. This part controls a valve that builds exhaust back pressure to help some diesels warm up faster. A wire shorted to power, an open circuit or a failed part is the usual reason.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check the exhaust pressure regulator solenoid wiring for shorts to other wires
- Measure the exhaust pressure regulator solenoid resistance and compare with spec
Signs you may notice
- Check engine light on
- Slower warm-up in cold weather
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailed exhaust pressure regulator vent solenoid
- CommonControl wire shorted to a power source
- PossibleOpen circuit or corroded connector
- PossibleEngine computer driver problem (rare)
Typical repair once the cause is confirmed
Repair any wiring fault first; if the wiring tests good, replace the exhaust pressure regulator vent solenoid.
Common questions
What does P2171 mean?
The control circuit for the exhaust pressure regulator vent solenoid is reading high voltage. This part controls a valve that builds exhaust back pressure to help some diesels warm up faster. A wire shorted to power, an open circuit or a failed part is the usual reason.
Can I drive with code P2171?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P2171?
Common possibilities to test include: failed exhaust pressure regulator vent solenoid; control wire shorted to a power source; open circuit or corroded connector; engine computer driver problem (rare). A shop should confirm the cause before replacing parts.