P2183 Engine Coolant Temperature Sensor 2 Circuit Range/Performance
What it means
The engine coolant temperature sensor 2 is giving readings that don't make sense compared with what the computer expects. This sensor gives the computer a second reading of engine coolant temperature. The sensor may be failing or the system it watches may have a real problem.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Compare the coolant temperature sensor reading with related sensors in live data
- Check wiring and connector for corrosion or looseness
Signs you may notice
- Check engine light on
- Temperature gauge may read wrong
- Cooling fans may run all the time
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailing or out-of-calibration coolant temperature sensor 2
- CommonLow coolant or a stuck thermostat
- PossibleHigh resistance in the wiring or connector
Typical repair once the cause is confirmed
Confirm the system itself is working, then replace the coolant temperature sensor 2 if its readings are off.
Common questions
What does P2183 mean?
The engine coolant temperature sensor 2 is giving readings that don't make sense compared with what the computer expects. This sensor gives the computer a second reading of engine coolant temperature. The sensor may be failing or the system it watches may have a real problem.
Can I drive with code P2183?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P2183?
Common possibilities to test include: failing or out-of-calibration coolant temperature sensor 2; low coolant or a stuck thermostat; high resistance in the wiring or connector. A shop should confirm the cause before replacing parts.