P2185 Engine Coolant Temperature Sensor 2 Circuit High
What it means
The signal from the engine coolant temperature sensor 2 is higher than the computer expects. This sensor gives the computer a second reading of engine coolant temperature. An open (broken) wire, a bad ground or a failed sensor is the usual reason.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Make sure the coolant temperature sensor connector is fully plugged in and clean
- Check the sensor ground and signal wire for an open circuit
Signs you may notice
- Check engine light on
- Temperature gauge may read wrong
- Cooling fans may run all the time
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonOpen or broken signal or ground wire
- CommonUnplugged or corroded connector
- PossibleFailed coolant temperature sensor 2
- PossibleWire shorted to a power source
Typical repair once the cause is confirmed
Repair any damaged wiring or connector first; if the circuit tests good, replace the coolant temperature sensor 2.
Common questions
What does P2185 mean?
The signal from the engine coolant temperature sensor 2 is higher than the computer expects. This sensor gives the computer a second reading of engine coolant temperature. An open (broken) wire, a bad ground or a failed sensor is the usual reason.
Can I drive with code P2185?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P2185?
Common possibilities to test include: open or broken signal or ground wire; unplugged or corroded connector; failed coolant temperature sensor 2; wire shorted to a power source. A shop should confirm the cause before replacing parts.