P2189 System Too Lean at Idle Bank 2
What it means
The engine on bank 2 (the side of the engine opposite cylinder 1) is running too lean at idle, and the computer has reached the limit of what it can correct. Too much air or too little fuel is getting in.
Can I keep driving?
Usually drivable while you arrange a check. If the idle gets very rough, it stalls at stops, or the check engine light starts flashing, get it checked soon, since stalling in traffic is a safety risk.
What to test before replacing parts
Smoke-test for vacuum and intake leaks on the bank 2 side, check fuel pressure and bank 2 injectors, and compare fuel trims between banks before replacing sensors.
- Listen and smoke-test for vacuum leaks
- Inspect and clean the MAF sensor
- Check fuel trims at idle and at higher RPM
Signs you may notice
- Check engine light on
- Rough or unstable idle
- Possible stalling
- Often no other symptoms
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonVacuum leak (cracked hose, intake gasket or PCV valve)
- CommonDirty or faulty mass airflow (MAF) sensor
- CommonLeaking intake manifold gasket
- PossibleLow fuel pressure or weak fuel pump
- PossibleExhaust leak before the front oxygen sensor
Typical repair once the cause is confirmed
Find and repair the leak or fuel delivery problem; replacing parts without testing rarely fixes it.
Common questions
What does P2189 mean?
The engine on bank 2 (the side of the engine opposite cylinder 1) is running too lean at idle, and the computer has reached the limit of what it can correct. Too much air or too little fuel is getting in.
Can I drive with code P2189?
Usually drivable while you arrange a check. If the idle gets very rough, it stalls at stops, or the check engine light starts flashing, get it checked soon, since stalling in traffic is a safety risk.
What causes P2189?
Common possibilities to test include: vacuum leak (cracked hose, intake gasket or pcv valve); dirty or faulty mass airflow (maf) sensor; leaking intake manifold gasket; low fuel pressure or weak fuel pump. A shop should confirm the cause before replacing parts.