P2199 Intake Air Temperature Sensor 1/2 Correlation
What it means
The vehicle has two intake air temperature sensors, and their readings don't agree with each other. One sensor or its wiring is usually at fault.
Can I keep driving?
Usually fine to drive normally; it rarely affects how the car runs. Get it checked when convenient. If other warning lights come on or the engine starts running poorly, have it looked at sooner.
What to test before replacing parts
Compare both intake air temperature readings to actual air temperature after the car sits overnight, check sensor wiring and connectors, and confirm which sensor is off before replacing.
- Compare both IAT readings in live data with the engine cold
- Inspect both sensor connectors and wiring
- Check for service bulletins for your vehicle
Signs you may notice
- Check engine light on
- Usually no change in how the car drives
- Possible small drop in fuel economy
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFaulty intake air temperature sensor (often inside the MAF sensor)
- CommonFaulty second IAT sensor (often in the intake manifold or MAP sensor)
- CommonLoose or corroded sensor connector
- PossibleHeat soak after a short hot shutdown
- PossibleDamaged wiring
Typical repair once the cause is confirmed
Replace whichever IAT sensor reads wrong, which is often part of the MAF or MAP sensor.
Common questions
What does P2199 mean?
The vehicle has two intake air temperature sensors, and their readings don't agree with each other. One sensor or its wiring is usually at fault.
Can I drive with code P2199?
Usually fine to drive normally; it rarely affects how the car runs. Get it checked when convenient. If other warning lights come on or the engine starts running poorly, have it looked at sooner.
What causes P2199?
Common possibilities to test include: faulty intake air temperature sensor (often inside the maf sensor); faulty second iat sensor (often in the intake manifold or map sensor); loose or corroded sensor connector; heat soak after a short hot shutdown. A shop should confirm the cause before replacing parts.