Home › Code lookup › P2419
Powertrain code · Emissions

P2419 Evaporative Emission System Switching Valve Control Circuit Low

How urgent? Book a check when convenient

What it means

The control circuit for the EVAP switching valve is reading low voltage. This part routes fuel vapor in the evaporative emissions system. A wire shorted to ground or a shorted part is the usual reason.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the EVAP switching valve wiring for rubbed-through insulation
  2. Measure the EVAP switching valve resistance and compare with spec

Signs you may notice

  • Check engine light on
  • Usually no change in how the car drives
  • May fail an emissions inspection

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonControl wire shorted to ground
  • CommonInternally shorted EVAP switching valve
  • PossibleDamaged connector
  • PossibleEngine computer driver problem (rare)

Typical repair once the cause is confirmed

Repair any wiring fault first; if the wiring tests good, replace the EVAP switching valve.

Repair costInsufficient verified pricing for this vehicle and repair
Replace EVAP switching valve. Prepare an itemized shop request.

Common questions

What does P2419 mean?

The control circuit for the EVAP switching valve is reading low voltage. This part routes fuel vapor in the evaporative emissions system. A wire shorted to ground or a shorted part is the usual reason.

Can I drive with code P2419?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P2419?

Common possibilities to test include: control wire shorted to ground; internally shorted evap switching valve; damaged connector; engine computer driver problem (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.