Home › Code lookup › P2427
Powertrain code · Emissions

P2427 Exhaust Gas Recirculation Cooling Valve Control Circuit High

How urgent? Book a check when convenient

What it means

The control circuit for the EGR cooler bypass valve is reading high voltage. This part sends exhaust gas through or around the EGR cooler. A wire shorted to power, an open circuit or a failed part is the usual reason.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the EGR cooler valve wiring for shorts to other wires
  2. Measure the EGR cooler valve resistance and compare with spec

Signs you may notice

  • Check engine light on
  • Usually little change in how the vehicle drives

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed EGR cooler bypass valve
  • CommonControl wire shorted to a power source
  • PossibleOpen circuit or corroded connector
  • PossibleEngine computer driver problem (rare)

Typical repair once the cause is confirmed

Repair any wiring fault first; if the wiring tests good, replace the EGR cooler bypass valve.

Repair costInsufficient verified pricing for this vehicle and repair
Replace EGR cooler bypass valve. Prepare an itemized shop request.

Common questions

What does P2427 mean?

The control circuit for the EGR cooler bypass valve is reading high voltage. This part sends exhaust gas through or around the EGR cooler. A wire shorted to power, an open circuit or a failed part is the usual reason.

Can I drive with code P2427?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P2427?

Common possibilities to test include: failed egr cooler bypass valve; control wire shorted to a power source; open circuit or corroded connector; engine computer driver problem (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.