P2435 Secondary Air Injection System Air Flow/Pressure Sensor Circuit Bank 2
What it means
The engine computer has found a problem in the circuit for the secondary air injection pressure sensor (bank 2), which checks that the air pump is blowing fresh air into the exhaust during cold starts. It usually points to wiring, a connector or the sensor itself.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the secondary air sensor connector and wiring for damage or corrosion
- Check the sensor power, ground and signal with a meter
Signs you may notice
- Check engine light on
- Usually no change in how the car drives
- May fail an emissions inspection
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFaulty secondary air injection pressure sensor
- CommonDamaged, corroded or unplugged connector
- PossibleBroken or chafed wiring
- PossibleEngine computer problem (rare)
Typical repair once the cause is confirmed
Repair any damaged wiring or connector first; if the circuit tests good, replace the secondary air injection pressure sensor.
Common questions
What does P2435 mean?
The engine computer has found a problem in the circuit for the secondary air injection pressure sensor (bank 2), which checks that the air pump is blowing fresh air into the exhaust during cold starts. It usually points to wiring, a connector or the sensor itself.
Can I drive with code P2435?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P2435?
Common possibilities to test include: faulty secondary air injection pressure sensor; damaged, corroded or unplugged connector; broken or chafed wiring; engine computer problem (rare). A shop should confirm the cause before replacing parts.