Home › Code lookup › P2438
Powertrain code · Emissions

P2438 Secondary Air Injection System Air Flow/Pressure Sensor Circuit High Bank 2

How urgent? Book a check when convenient

What it means

The signal from the secondary air injection pressure sensor (bank 2) is higher than the computer expects. This sensor checks that the air pump is blowing fresh air into the exhaust during cold starts. An open (broken) wire, a bad ground or a failed sensor is the usual reason.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Make sure the secondary air sensor connector is fully plugged in and clean
  2. Check the sensor ground and signal wire for an open circuit

Signs you may notice

  • Check engine light on
  • Usually no change in how the car drives
  • May fail an emissions inspection

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonOpen or broken signal or ground wire
  • CommonUnplugged or corroded connector
  • PossibleFailed secondary air injection pressure sensor
  • PossibleWire shorted to a power source

Typical repair once the cause is confirmed

Repair any damaged wiring or connector first; if the circuit tests good, replace the secondary air injection pressure sensor.

Repair costInsufficient verified pricing for this vehicle and repair
Replace secondary air injection pressure sensor. Prepare an itemized shop request.

Common questions

What does P2438 mean?

The signal from the secondary air injection pressure sensor (bank 2) is higher than the computer expects. This sensor checks that the air pump is blowing fresh air into the exhaust during cold starts. An open (broken) wire, a bad ground or a failed sensor is the usual reason.

Can I drive with code P2438?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P2438?

Common possibilities to test include: open or broken signal or ground wire; unplugged or corroded connector; failed secondary air injection pressure sensor; wire shorted to a power source. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.