P2440 Secondary Air Injection System Switching Valve Stuck Open Bank 1
What it means
The valve that lets fresh air from the secondary air pump into the exhaust on bank 1 (the side of the engine with cylinder 1) seems stuck open. This system only runs for a short time after a cold start.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check whether air flows through the valve when it should be closed or open
- Inspect the valve and hoses for water damage or corrosion
Signs you may notice
- Check engine light on
- Possible loud whine or roar from the air pump after a cold start
- May fail an emissions inspection
- Some vehicles go into limp mode
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailed secondary air switching (check) valve
- CommonMoisture or corrosion inside the valve
- PossibleFaulty air pressure sensor
- PossibleWiring or vacuum control problem
Typical repair once the cause is confirmed
Replace the stuck switching valve; water-damaged pumps often need replacing too.
Where it shows up
- Known on Toyota Tundra and Sequoia V8s and some Lexus models with secondary air injection
Known on these vehicles
Common questions
What does P2440 mean?
The valve that lets fresh air from the secondary air pump into the exhaust on bank 1 (the side of the engine with cylinder 1) seems stuck open. This system only runs for a short time after a cold start.
Can I drive with code P2440?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P2440?
Common possibilities to test include: failed secondary air switching (check) valve; moisture or corrosion inside the valve; faulty air pressure sensor; wiring or vacuum control problem. A shop should confirm the cause before replacing parts.