Home › Code lookup › P2443
Powertrain code · Emissions

P2443 Secondary Air Injection System Switching Valve Stuck Closed Bank 2

How urgent? Book a check when convenient

What it means

The valve that lets fresh air from the secondary air pump into the exhaust on bank 2 (the side of the engine opposite cylinder 1) seems stuck closed. This system only runs for a short time after a cold start.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check whether air flows through the valve when it should be closed or open
  2. Inspect the valve and hoses for water damage or corrosion

Signs you may notice

  • Check engine light on
  • Usually no change in how the car drives
  • May fail an emissions inspection
  • Some vehicles go into limp mode

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed secondary air switching (check) valve
  • CommonMoisture or corrosion inside the valve
  • PossibleFaulty air pressure sensor
  • PossibleWiring or vacuum control problem

Typical repair once the cause is confirmed

Replace the stuck switching valve; water-damaged pumps often need replacing too.

Repair costInsufficient verified pricing for this vehicle and repair
Replace secondary air switching valve. Prepare an itemized shop request.

Where it shows up

  • Known on Toyota Tundra and Sequoia V8s and some Lexus models with secondary air injection

Common questions

What does P2443 mean?

The valve that lets fresh air from the secondary air pump into the exhaust on bank 2 (the side of the engine opposite cylinder 1) seems stuck closed. This system only runs for a short time after a cold start.

Can I drive with code P2443?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P2443?

Common possibilities to test include: failed secondary air switching (check) valve; moisture or corrosion inside the valve; faulty air pressure sensor; wiring or vacuum control problem. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.