Home › Code lookup › P244B
Powertrain code · Emissions

P244B Diesel Particulate Filter Differential Pressure Too High Bank 1

How urgent? Get it checked in the next few days

What it means

The pressure difference across the diesel particulate filter is higher than it should be, meaning the filter is clogged or the sensor is misreading.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check DPF pressure readings and soot load with a scan tool
  2. Inspect sensor hoses and run a forced regeneration if allowed

Signs you may notice

  • Check engine light on
  • Reduced engine power
  • Frequent regeneration attempts

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFilter clogged with soot or ash
  • CommonFaulty DPF pressure sensor
  • PossiblePlugged sensor hose
  • PossibleExhaust restriction after the filter

Typical repair once the cause is confirmed

Run a forced regeneration; if that doesn't clear it, clean or replace the filter or sensor.

Repair costInsufficient verified pricing for this vehicle and repair
Forced DPF regeneration or filter cleaning. Prepare an itemized shop request.
Walk through it step by step: Reduced engine power / limp mode →

Common questions

What does P244B mean?

The pressure difference across the diesel particulate filter is higher than it should be, meaning the filter is clogged or the sensor is misreading.

Can I drive with code P244B?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P244B?

Common possibilities to test include: filter clogged with soot or ash; faulty dpf pressure sensor; plugged sensor hose; exhaust restriction after the filter. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.