Home › Code lookup › P2455
Powertrain code · Emissions

P2455 Diesel Particulate Filter Pressure Sensor "A" Circuit High

How urgent? Get it checked in the next few days

What it means

The signal from the diesel particulate filter (DPF) pressure sensor is higher than the computer expects. This sensor measures pressure across the diesel particulate filter to tell how full of soot it is. An open (broken) wire, a bad ground or a failed sensor is the usual reason.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Make sure the DPF pressure sensor connector is fully plugged in and clean
  2. Check the sensor ground and signal wire for an open circuit

Signs you may notice

  • Check engine light on
  • Filter cleaning (regeneration) may run too often or not at all
  • Possible reduced engine power

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonOpen or broken signal or ground wire
  • CommonUnplugged or corroded connector
  • PossibleFailed DPF differential pressure sensor
  • PossibleWire shorted to a power source

Typical repair once the cause is confirmed

Repair any damaged wiring or connector first; if the circuit tests good, replace the DPF differential pressure sensor.

Repair costInsufficient verified pricing for this vehicle and repair
Replace DPF differential pressure sensor. Prepare an itemized shop request.

Common questions

What does P2455 mean?

The signal from the diesel particulate filter (DPF) pressure sensor is higher than the computer expects. This sensor measures pressure across the diesel particulate filter to tell how full of soot it is. An open (broken) wire, a bad ground or a failed sensor is the usual reason.

Can I drive with code P2455?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2455?

Common possibilities to test include: open or broken signal or ground wire; unplugged or corroded connector; failed dpf differential pressure sensor; wire shorted to a power source. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.