Home › Code lookup › P2456
Powertrain code · Emissions

P2456 Diesel Particulate Filter Pressure Sensor "A" Circuit Intermittent/Erratic

How urgent? Get it checked in the next few days

What it means

The signal from the diesel particulate filter (DPF) pressure sensor keeps dropping out or jumping around. This sensor measures pressure across the diesel particulate filter to tell how full of soot it is. A loose connection or a damaged wire is the usual reason.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Wiggle the harness and connector while watching live data for dropouts
  2. Inspect the DPF pressure sensor wiring along its whole route

Signs you may notice

  • Check engine light on
  • Filter cleaning (regeneration) may run too often or not at all
  • Possible reduced engine power

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonLoose or corroded connector
  • CommonChafed wire that opens or shorts as the engine moves
  • PossibleFailing DPF differential pressure sensor

Typical repair once the cause is confirmed

Repair any damaged wiring or connector first; if the circuit tests good, replace the DPF differential pressure sensor.

Repair costInsufficient verified pricing for this vehicle and repair
Replace DPF differential pressure sensor. Prepare an itemized shop request.

Common questions

What does P2456 mean?

The signal from the diesel particulate filter (DPF) pressure sensor keeps dropping out or jumping around. This sensor measures pressure across the diesel particulate filter to tell how full of soot it is. A loose connection or a damaged wire is the usual reason.

Can I drive with code P2456?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P2456?

Common possibilities to test include: loose or corroded connector; chafed wire that opens or shorts as the engine moves; failing dpf differential pressure sensor. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.