P2813 Pressure Control Solenoid "G" Control Circuit Range/Performance
What it means
The computer is watching the pressure control solenoid "G" control circuit and is getting a signal that does not make sense for current conditions. This solenoid inside the automatic transmission sets the fluid pressure that applies the clutches during shifts.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check for other codes that point to the underlying problem
- Compare the pressure control solenoid "G" control circuit reading with expected values in live data
- Inspect the wiring and connector
Signs you may notice
- Check engine or transmission warning light on
- Harsh, late or erratic shifts
- Transmission may go into limp mode (stuck in one gear)
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailing or sticking pressure control solenoid "G"
- CommonLow, dirty or wrong transmission fluid
- PossibleWiring or connector with high resistance
- PossibleComputer software that needs an update
Typical repair once the cause is confirmed
Find out whether the pressure control solenoid "G" itself or the system it works with is at fault, then repair or replace as needed.
Common questions
What does P2813 mean?
The computer is watching the pressure control solenoid "G" control circuit and is getting a signal that does not make sense for current conditions. This solenoid inside the automatic transmission sets the fluid pressure that applies the clutches during shifts.
Can I drive with code P2813?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P2813?
Common possibilities to test include: failing or sticking pressure control solenoid "g"; low, dirty or wrong transmission fluid; wiring or connector with high resistance; computer software that needs an update. A shop should confirm the cause before replacing parts.