Home › Code lookup › P282A
Powertrain code · Transmission

P282A Pressure Control Solenoid "K" Stuck On

How urgent? Get it checked in the next few days

What it means

The computer thinks the pressure control solenoid "K" is stuck on. This solenoid inside the automatic transmission sets the fluid pressure that applies the clutches during shifts.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the transmission fluid level and condition
  2. Look for other transmission codes
  3. Have the solenoid tested and commanded with a scan tool

Signs you may notice

  • Check engine or transmission warning light on
  • Harsh, late or erratic shifts
  • Transmission may go into limp mode (stuck in one gear)

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonSticking pressure control solenoid "K"
  • CommonLow, dirty or wrong transmission fluid
  • PossibleWorn valve body or internal fluid leak
  • PossibleWorn clutches inside the transmission

Typical repair once the cause is confirmed

Service the fluid if it is low or dirty; if the code returns, replace pressure control solenoid "K" or the valve body it sits in.

Walk through it step by step: Transmission warning light on →

Common questions

What does P282A mean?

The computer thinks the pressure control solenoid "K" is stuck on. This solenoid inside the automatic transmission sets the fluid pressure that applies the clutches during shifts.

Can I drive with code P282A?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P282A?

Common possibilities to test include: sticking pressure control solenoid "k"; low, dirty or wrong transmission fluid; worn valve body or internal fluid leak; worn clutches inside the transmission. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.