Home › Code lookup › P0729
Powertrain code · Transmission

P0729 Gear 6 Incorrect Ratio

How urgent? Get it checked in the next few days

What it means

The computer compared the speeds going into and out of the transmission and found they don't match what sixth gear should give, which usually means something is slipping.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check fluid level, color and smell (dark or burnt fluid points to internal wear)
  2. Check for solenoid or speed sensor codes and fix those first

Signs you may notice

  • Check engine light on
  • Slipping or flaring RPM during or after a shift
  • Delayed, harsh or missing gear

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonLow, burnt or wrong transmission fluid
  • CommonWorn clutches or bands inside the transmission
  • CommonFaulty shift solenoid or pressure control solenoid

Typical repair once the cause is confirmed

Check and correct the fluid first. If solenoids and sensors test good, the transmission usually needs internal repair or a rebuild.

Walk through it step by step: Transmission slipping →

Common questions

What does P0729 mean?

The computer compared the speeds going into and out of the transmission and found they don't match what sixth gear should give, which usually means something is slipping.

Can I drive with code P0729?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0729?

Common possibilities to test include: low, burnt or wrong transmission fluid; worn clutches or bands inside the transmission; faulty shift solenoid or pressure control solenoid. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.