Home › Code lookup › P076F
Powertrain code · Transmission

P076F Gear 7 Incorrect Ratio

How urgent? Get it checked in the next few days

What it means

The computer compared the speeds going into and out of the transmission and found they don't match what seventh gear should give, which usually means something is slipping.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check fluid level and condition
  2. Check for solenoid or speed sensor codes and fix those first

Signs you may notice

  • Check engine light on
  • Slipping or flaring RPM in the higher gears
  • Transmission may go into limp mode

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonLow, burnt or wrong transmission fluid
  • CommonWorn clutch inside the transmission
  • CommonFaulty shift or pressure control solenoid
  • PossibleFaulty speed sensor

Typical repair once the cause is confirmed

Check and correct the fluid first. If solenoids and sensors test good, the transmission usually needs internal repair.

Walk through it step by step: Transmission slipping →

Common questions

What does P076F mean?

The computer compared the speeds going into and out of the transmission and found they don't match what seventh gear should give, which usually means something is slipping.

Can I drive with code P076F?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P076F?

Common possibilities to test include: low, burnt or wrong transmission fluid; worn clutch inside the transmission; faulty shift or pressure control solenoid; faulty speed sensor. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.