P081B Starter Disable Circuit High
What it means
The computer sees a signal or voltage in the starter disable circuit circuit that is higher than it should be. The starter disable circuit lets the computer block the starter unless it is safe to crank, such as in Park or with the clutch pressed.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check the connector for pushed-out or loose pins
- Check the starter disable circuit circuit for an open wire or a short to voltage
- Test the starter disable circuit against the factory specification
Signs you may notice
- Engine may not crank, or only cranks some of the time
- Check engine light on
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonOpen or broken wire in the starter disable circuit circuit
- PossiblePark/neutral or clutch switch problem
- CommonFailed starter relay or starter disable relay
- PossibleWire shorted to another power circuit
- PossiblePoor ground or loose connector
- PossibleFaulty control module (rare)
Typical repair once the cause is confirmed
Repair the open or shorted wire or bad connector; if the wiring is good, replace the starter disable circuit.
Common questions
What does P081B mean?
The computer sees a signal or voltage in the starter disable circuit circuit that is higher than it should be. The starter disable circuit lets the computer block the starter unless it is safe to crank, such as in Park or with the clutch pressed.
Can I drive with code P081B?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P081B?
Common possibilities to test include: open or broken wire in the starter disable circuit circuit; park/neutral or clutch switch problem; failed starter relay or starter disable relay; wire shorted to another power circuit. A shop should confirm the cause before replacing parts.