Home › Code lookup › P0822
Powertrain code · Transmission

P0822 Gear Lever Y Position Circuit

How urgent? Get it checked in the next few days

What it means

The computer found an electrical problem in the circuit for the gear lever position sensor, which tells the transmission computer where the shift lever is on shift-by-wire or automated manual systems.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Look over the wiring and connector at the gear lever sensor for damage, rubbing or corrosion
  2. Check related fuses, power and ground with a meter
  3. Test the gear lever sensor against the factory specification before replacing it

Signs you may notice

  • Transmission warning or check engine light on
  • Gear selected may not match the lever, or gears may be refused
  • Transmission may go into a default gear

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed gear lever position sensor
  • CommonBroken or damaged wiring to the gear lever sensor
  • CommonLoose, corroded or water-damaged connector
  • PossibleBlown fuse or missing power or ground
  • PossibleFaulty transmission or engine computer (rare)

Typical repair once the cause is confirmed

Repair any wiring or connector fault found; if the circuit tests good, replace the gear lever sensor.

Common questions

What does P0822 mean?

The computer found an electrical problem in the circuit for the gear lever position sensor, which tells the transmission computer where the shift lever is on shift-by-wire or automated manual systems.

Can I drive with code P0822?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0822?

Common possibilities to test include: failed gear lever position sensor; broken or damaged wiring to the gear lever sensor; loose, corroded or water-damaged connector; blown fuse or missing power or ground. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.