Home › Code lookup › P0828
Powertrain code · Transmission

P0828 Up and Down Shift Switch Circuit High

How urgent? Book a check when convenient

What it means

The computer sees a signal or voltage in the up and down shift switch circuit that is higher than it should be. The shift switch sends your manual upshift and downshift requests (from the shifter or paddles) to the transmission computer.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the connector for pushed-out or loose pins
  2. Check the shift switch circuit for an open wire or a short to voltage
  3. Test the shift switch against the factory specification

Signs you may notice

  • Manual or paddle shifting may not work
  • Check engine light on
  • Normal automatic shifting in Drive usually still works

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonOpen or broken wire in the shift switch circuit
  • CommonFailed up/down shift switch
  • PossibleWire shorted to another power circuit
  • PossiblePoor ground or loose connector
  • PossibleFaulty control module (rare)

Typical repair once the cause is confirmed

Repair the open or shorted wire or bad connector; if the wiring is good, replace the shift switch.

Repair costInsufficient verified pricing for this vehicle and repair
Replace up/down shift switch. Prepare an itemized shop request.

Common questions

What does P0828 mean?

The computer sees a signal or voltage in the up and down shift switch circuit that is higher than it should be. The shift switch sends your manual upshift and downshift requests (from the shifter or paddles) to the transmission computer.

Can I drive with code P0828?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P0828?

Common possibilities to test include: open or broken wire in the shift switch circuit; failed up/down shift switch; wire shorted to another power circuit; poor ground or loose connector. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.