P083D Transmission Fluid Pressure Sensor/Switch G Circuit High
What it means
The computer sees a signal or voltage in the transmission fluid pressure sensor/switch G circuit that is higher than it should be. The pressure sensor/switch reports hydraulic pressure (or on some transmissions, the selected gear range) to the transmission computer.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check the connector for pushed-out or loose pins
- Check the pressure sensor/switch circuit for an open wire or a short to voltage
- Test the pressure sensor/switch against the factory specification
Signs you may notice
- Check engine light on
- Harsh, late or erratic shifting
- Transmission may stay in one gear (limp mode)
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonOpen or broken wire in the pressure sensor/switch circuit
- CommonFailed transmission fluid pressure sensor/switch
- PossibleWire shorted to another power circuit
- PossiblePoor ground or loose connector
- PossibleFaulty control module (rare)
Typical repair once the cause is confirmed
Repair the open or shorted wire or bad connector; if the wiring is good, replace the pressure sensor/switch.
Common questions
What does P083D mean?
The computer sees a signal or voltage in the transmission fluid pressure sensor/switch G circuit that is higher than it should be. The pressure sensor/switch reports hydraulic pressure (or on some transmissions, the selected gear range) to the transmission computer.
Can I drive with code P083D?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P083D?
Common possibilities to test include: open or broken wire in the pressure sensor/switch circuit; failed transmission fluid pressure sensor/switch; wire shorted to another power circuit; poor ground or loose connector. A shop should confirm the cause before replacing parts.