Home › Code lookup › P0842
Powertrain code · Transmission

P0842 Transmission Fluid Pressure Sensor/Switch A Circuit Low

How urgent? Get it checked in the next few days

What it means

The computer sees a signal or voltage in the transmission fluid pressure sensor/switch A circuit that is lower than it should be. The pressure sensor/switch reports hydraulic pressure (or on some transmissions, the selected gear range) to the transmission computer.

Can I keep driving?

Use care. This can mean real low fluid pressure or just a sensor circuit fault. If shifting is normal, drive gently to a shop soon. If it slips, stays in one gear, or you see a leak or warning message, stop driving, because real low pressure can quickly damage the transmission.

What to test before replacing parts

Check fluid level, then verify actual line pressure with a gauge and test the sensor wiring for a short to ground before replacing the sensor.

  1. Inspect the pressure sensor/switch wiring for chafed spots touching metal
  2. Check the circuit for a short to ground with a meter
  3. Unplug the pressure sensor/switch and see whether the reading changes

Signs you may notice

  • Check engine light on
  • Harsh, late or erratic shifting
  • Transmission may stay in one gear (limp mode)

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed transmission fluid pressure sensor/switch
  • CommonWire shorted to ground in the sensor circuit
  • PossibleFluid getting into the connector
  • PossibleFaulty transmission computer (rare)

Typical repair once the cause is confirmed

Fix any shorted or damaged wiring; if the wiring is good, replace the pressure sensor/switch.

Repair costInsufficient verified pricing for this vehicle and repair
Replace transmission fluid pressure sensor/switch. Prepare an itemized shop request.
Walk through it step by step: Harsh or late shifting →

Common questions

What does P0842 mean?

The computer sees a signal or voltage in the transmission fluid pressure sensor/switch A circuit that is lower than it should be. The pressure sensor/switch reports hydraulic pressure (or on some transmissions, the selected gear range) to the transmission computer.

Can I drive with code P0842?

Use care. This can mean real low fluid pressure or just a sensor circuit fault. If shifting is normal, drive gently to a shop soon. If it slips, stays in one gear, or you see a leak or warning message, stop driving, because real low pressure can quickly damage the transmission.

What causes P0842?

Common possibilities to test include: failed transmission fluid pressure sensor/switch; wire shorted to ground in the sensor circuit; fluid getting into the connector; faulty transmission computer (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.