Home › Code lookup › P0845
Powertrain code · Transmission

P0845 Transmission Fluid Pressure Sensor/Switch B Circuit

How urgent? Get it checked in the next few days

What it means

The computer found an electrical problem in the circuit for the transmission fluid pressure sensor/switch B, which reports hydraulic pressure (or on some transmissions, the selected gear range) to the transmission computer.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Look over the wiring and connector at the pressure sensor/switch for damage, rubbing or corrosion
  2. Check related fuses, power and ground with a meter
  3. Test the pressure sensor/switch against the factory specification before replacing it

Signs you may notice

  • Check engine light on
  • Harsh, late or erratic shifting
  • Transmission may stay in one gear (limp mode)

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed transmission fluid pressure sensor/switch
  • CommonBroken or damaged wiring to the pressure sensor/switch
  • CommonLoose, corroded or water-damaged connector
  • PossibleBlown fuse or missing power or ground
  • PossibleFaulty transmission or engine computer (rare)

Typical repair once the cause is confirmed

Repair any wiring or connector fault found; if the circuit tests good, replace the pressure sensor/switch.

Repair costInsufficient verified pricing for this vehicle and repair
Replace transmission fluid pressure sensor/switch. Prepare an itemized shop request.
Walk through it step by step: Harsh or late shifting →

Common questions

What does P0845 mean?

The computer found an electrical problem in the circuit for the transmission fluid pressure sensor/switch B, which reports hydraulic pressure (or on some transmissions, the selected gear range) to the transmission computer.

Can I drive with code P0845?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0845?

Common possibilities to test include: failed transmission fluid pressure sensor/switch; broken or damaged wiring to the pressure sensor/switch; loose, corroded or water-damaged connector; blown fuse or missing power or ground. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.