Home › Code lookup › P0846
Powertrain code · Transmission

P0846 Transmission Fluid Pressure Sensor/Switch B Circuit Range/Performance

How urgent? Get it checked in the next few days

What it means

The transmission fluid pressure sensor/switch B is giving readings that don't match what the computer expects for the current conditions. The pressure sensor/switch reports hydraulic pressure (or on some transmissions, the selected gear range) to the transmission computer.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the transmission fluid level and condition
  2. Compare the pressure sensor/switch reading with what it should be on a scan tool
  3. Inspect the wiring and connector for corrosion or damage

Signs you may notice

  • Check engine light on
  • Harsh, late or erratic shifting
  • Transmission may stay in one gear (limp mode)

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailing transmission fluid pressure sensor/switch
  • CommonLow, dirty or burnt transmission fluid
  • PossibleSticking valve or blocked passage in the valve body
  • PossibleHigh resistance in the wiring or connector
  • PossibleControl module software needs an update

Typical repair once the cause is confirmed

Correct any fluid or wiring problem first; if the readings are still wrong, replace the pressure sensor/switch.

Repair costInsufficient verified pricing for this vehicle and repair
Replace transmission fluid pressure sensor/switch. Prepare an itemized shop request.
Walk through it step by step: Harsh or late shifting →

Common questions

What does P0846 mean?

The transmission fluid pressure sensor/switch B is giving readings that don't match what the computer expects for the current conditions. The pressure sensor/switch reports hydraulic pressure (or on some transmissions, the selected gear range) to the transmission computer.

Can I drive with code P0846?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0846?

Common possibilities to test include: failing transmission fluid pressure sensor/switch; low, dirty or burnt transmission fluid; sticking valve or blocked passage in the valve body; high resistance in the wiring or connector. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.