P0851 Park/Neutral Switch Input Circuit Low
What it means
The computer sees a signal or voltage in the park/neutral position switch circuit that is lower than it should be. The park/neutral switch tells the engine computer when the transmission is in Park or Neutral.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the park/neutral switch wiring for chafed spots touching metal
- Check the circuit for a short to ground with a meter
- Unplug the park/neutral switch and see whether the reading changes
Signs you may notice
- Check engine light on
- Engine may not crank, or may only crank in Neutral
- Gear indicator or idle quality may be slightly off
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonWire shorted to ground in the park/neutral switch circuit
- CommonSwitch or shift cable out of adjustment
- CommonFailed park/neutral position switch (internal short)
- PossibleCorroded or water-damaged connector
- PossibleFaulty control module (rare)
Typical repair once the cause is confirmed
Fix any shorted or damaged wiring; if the wiring is good, replace the park/neutral switch.
Common questions
What does P0851 mean?
The computer sees a signal or voltage in the park/neutral position switch circuit that is lower than it should be. The park/neutral switch tells the engine computer when the transmission is in Park or Neutral.
Can I drive with code P0851?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P0851?
Common possibilities to test include: wire shorted to ground in the park/neutral switch circuit; switch or shift cable out of adjustment; failed park/neutral position switch (internal short); corroded or water-damaged connector. A shop should confirm the cause before replacing parts.