P0852 Park/Neutral Switch Input Circuit High
What it means
The computer sees a signal or voltage in the park/neutral position switch circuit that is higher than it should be. The park/neutral switch tells the engine computer when the transmission is in Park or Neutral.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check the connector for pushed-out or loose pins
- Check the park/neutral switch circuit for an open wire or a short to voltage
- Test the park/neutral switch against the factory specification
Signs you may notice
- Check engine light on
- Engine may not crank, or may only crank in Neutral
- Gear indicator or idle quality may be slightly off
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonOpen or broken wire in the park/neutral switch circuit
- CommonSwitch or shift cable out of adjustment
- CommonFailed park/neutral position switch
- PossibleWire shorted to another power circuit
- PossiblePoor ground or loose connector
- PossibleFaulty control module (rare)
Typical repair once the cause is confirmed
Repair the open or shorted wire or bad connector; if the wiring is good, replace the park/neutral switch.
Common questions
What does P0852 mean?
The computer sees a signal or voltage in the park/neutral position switch circuit that is higher than it should be. The park/neutral switch tells the engine computer when the transmission is in Park or Neutral.
Can I drive with code P0852?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P0852?
Common possibilities to test include: open or broken wire in the park/neutral switch circuit; switch or shift cable out of adjustment; failed park/neutral position switch; wire shorted to another power circuit. A shop should confirm the cause before replacing parts.