Home › Code lookup › P0853
Powertrain code · Transmission

P0853 Drive Switch Input Circuit

How urgent? Book a check when convenient

What it means

The computer found an electrical problem in the circuit for the drive switch input, which lets the computer know when the transmission has been put in Drive.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Look over the wiring and connector at the drive switch for damage, rubbing or corrosion
  2. Check related fuses, power and ground with a meter
  3. Test the drive switch against the factory specification before replacing it

Signs you may notice

  • Check engine light on
  • Gear indicator may be wrong
  • Idle or shift quality may change slightly

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed drive switch or range sensor
  • PossibleRange sensor or shift cable out of adjustment
  • CommonBroken or damaged wiring to the drive switch
  • CommonLoose, corroded or water-damaged connector
  • PossibleBlown fuse or missing power or ground
  • PossibleFaulty transmission or engine computer (rare)

Typical repair once the cause is confirmed

Repair any wiring or connector fault found; if the circuit tests good, replace the drive switch.

Common questions

What does P0853 mean?

The computer found an electrical problem in the circuit for the drive switch input, which lets the computer know when the transmission has been put in Drive.

Can I drive with code P0853?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P0853?

Common possibilities to test include: failed drive switch or range sensor; range sensor or shift cable out of adjustment; broken or damaged wiring to the drive switch; loose, corroded or water-damaged connector. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.