Home › Code lookup › P0854
Powertrain code · Transmission

P0854 Drive Switch Input Circuit Low

How urgent? Book a check when convenient

What it means

The computer sees a signal or voltage in the drive switch input circuit that is lower than it should be. The drive switch lets the computer know when the transmission has been put in Drive.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the drive switch wiring for chafed spots touching metal
  2. Check the circuit for a short to ground with a meter
  3. Unplug the drive switch and see whether the reading changes

Signs you may notice

  • Check engine light on
  • Gear indicator may be wrong
  • Idle or shift quality may change slightly

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonWire shorted to ground in the drive switch circuit
  • PossibleRange sensor or shift cable out of adjustment
  • CommonFailed drive switch or range sensor (internal short)
  • PossibleCorroded or water-damaged connector
  • PossibleFaulty control module (rare)

Typical repair once the cause is confirmed

Fix any shorted or damaged wiring; if the wiring is good, replace the drive switch.

Common questions

What does P0854 mean?

The computer sees a signal or voltage in the drive switch input circuit that is lower than it should be. The drive switch lets the computer know when the transmission has been put in Drive.

Can I drive with code P0854?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P0854?

Common possibilities to test include: wire shorted to ground in the drive switch circuit; range sensor or shift cable out of adjustment; failed drive switch or range sensor (internal short); corroded or water-damaged connector. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.