Home › Code lookup › P0855
Powertrain code · Transmission

P0855 Drive Switch Input Circuit High

How urgent? Book a check when convenient

What it means

The computer sees a signal or voltage in the drive switch input circuit that is higher than it should be. The drive switch lets the computer know when the transmission has been put in Drive.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the connector for pushed-out or loose pins
  2. Check the drive switch circuit for an open wire or a short to voltage
  3. Test the drive switch against the factory specification

Signs you may notice

  • Check engine light on
  • Gear indicator may be wrong
  • Idle or shift quality may change slightly

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonOpen or broken wire in the drive switch circuit
  • PossibleRange sensor or shift cable out of adjustment
  • CommonFailed drive switch or range sensor
  • PossibleWire shorted to another power circuit
  • PossiblePoor ground or loose connector
  • PossibleFaulty control module (rare)

Typical repair once the cause is confirmed

Repair the open or shorted wire or bad connector; if the wiring is good, replace the drive switch.

Common questions

What does P0855 mean?

The computer sees a signal or voltage in the drive switch input circuit that is higher than it should be. The drive switch lets the computer know when the transmission has been put in Drive.

Can I drive with code P0855?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P0855?

Common possibilities to test include: open or broken wire in the drive switch circuit; range sensor or shift cable out of adjustment; failed drive switch or range sensor; wire shorted to another power circuit. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.