P0856 Traction Control Input Signal
What it means
The computer found an electrical problem in the circuit for the traction control input signal, which is the message the engine or transmission computer gets from the ABS and traction control system.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Look over the wiring and connector at the traction control signal for damage, rubbing or corrosion
- Check related fuses, power and ground with a meter
- Test the traction control signal against the factory specification before replacing it
Signs you may notice
- Check engine light on
- Traction control or ABS light may also be on
- Traction control may switch itself off
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailed ABS/traction control module
- CommonFault stored in the ABS/traction control module (scan it too)
- CommonBroken or damaged wiring to the traction control signal
- CommonLoose, corroded or water-damaged connector
- PossibleBlown fuse or missing power or ground
- PossibleFaulty transmission or engine computer (rare)
Typical repair once the cause is confirmed
Repair any wiring or connector fault found; if the circuit tests good, replace the traction control signal.
Common questions
What does P0856 mean?
The computer found an electrical problem in the circuit for the traction control input signal, which is the message the engine or transmission computer gets from the ABS and traction control system.
Can I drive with code P0856?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P0856?
Common possibilities to test include: failed abs/traction control module; fault stored in the abs/traction control module (scan it too); broken or damaged wiring to the traction control signal; loose, corroded or water-damaged connector. A shop should confirm the cause before replacing parts.