P0858 Traction Control Input Signal Low
What it means
The computer sees a signal or voltage in the traction control input signal circuit that is lower than it should be. The traction control signal is the message the engine or transmission computer gets from the ABS and traction control system.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the traction control signal wiring for chafed spots touching metal
- Check the circuit for a short to ground with a meter
- Unplug the traction control signal and see whether the reading changes
Signs you may notice
- Check engine light on
- Traction control or ABS light may also be on
- Traction control may switch itself off
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonWire shorted to ground in the traction control signal circuit
- CommonFault stored in the ABS/traction control module (scan it too)
- CommonFailed ABS/traction control module (internal short)
- PossibleCorroded or water-damaged connector
- PossibleFaulty control module (rare)
Typical repair once the cause is confirmed
Fix any shorted or damaged wiring; if the wiring is good, replace the traction control signal.
Common questions
What does P0858 mean?
The computer sees a signal or voltage in the traction control input signal circuit that is lower than it should be. The traction control signal is the message the engine or transmission computer gets from the ABS and traction control system.
Can I drive with code P0858?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P0858?
Common possibilities to test include: wire shorted to ground in the traction control signal circuit; fault stored in the abs/traction control module (scan it too); failed abs/traction control module (internal short); corroded or water-damaged connector. A shop should confirm the cause before replacing parts.