P0859 Traction Control Input Signal High
What it means
The computer sees a signal or voltage in the traction control input signal circuit that is higher than it should be. The traction control signal is the message the engine or transmission computer gets from the ABS and traction control system.
Can I keep driving?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check the connector for pushed-out or loose pins
- Check the traction control signal circuit for an open wire or a short to voltage
- Test the traction control signal against the factory specification
Signs you may notice
- Check engine light on
- Traction control or ABS light may also be on
- Traction control may switch itself off
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonOpen or broken wire in the traction control signal circuit
- CommonFault stored in the ABS/traction control module (scan it too)
- CommonFailed ABS/traction control module
- PossibleWire shorted to another power circuit
- PossiblePoor ground or loose connector
- PossibleFaulty control module (rare)
Typical repair once the cause is confirmed
Repair the open or shorted wire or bad connector; if the wiring is good, replace the traction control signal.
Common questions
What does P0859 mean?
The computer sees a signal or voltage in the traction control input signal circuit that is higher than it should be. The traction control signal is the message the engine or transmission computer gets from the ABS and traction control system.
Can I drive with code P0859?
Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.
What causes P0859?
Common possibilities to test include: open or broken wire in the traction control signal circuit; fault stored in the abs/traction control module (scan it too); failed abs/traction control module; wire shorted to another power circuit. A shop should confirm the cause before replacing parts.