P0861 Gear Shift Module Communication Circuit Low
What it means
The computer sees a signal or voltage in the gear shift module communication circuit circuit that is lower than it should be. The shift module data line carries messages between the shifter module and the transmission computer.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the shift module data line wiring for chafed spots touching metal
- Check the circuit for a short to ground with a meter
- Unplug the shift module data line and see whether the reading changes
Signs you may notice
- Check engine light on
- Shifter or gear display may not respond correctly
- Transmission may go into a default gear
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonWire shorted to ground in the shift module data line circuit
- CommonFailed gear shift (shifter) module (internal short)
- PossibleCorroded or water-damaged connector
- PossibleFaulty control module (rare)
Typical repair once the cause is confirmed
Fix any shorted or damaged wiring; if the wiring is good, replace the shift module data line.
Common questions
What does P0861 mean?
The computer sees a signal or voltage in the gear shift module communication circuit circuit that is lower than it should be. The shift module data line carries messages between the shifter module and the transmission computer.
Can I drive with code P0861?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P0861?
Common possibilities to test include: wire shorted to ground in the shift module data line circuit; failed gear shift (shifter) module (internal short); corroded or water-damaged connector; faulty control module (rare). A shop should confirm the cause before replacing parts.