P0862 Gear Shift Module Communication Circuit High
What it means
The computer sees a signal or voltage in the gear shift module communication circuit circuit that is higher than it should be. The shift module data line carries messages between the shifter module and the transmission computer.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check the connector for pushed-out or loose pins
- Check the shift module data line circuit for an open wire or a short to voltage
- Test the shift module data line against the factory specification
Signs you may notice
- Check engine light on
- Shifter or gear display may not respond correctly
- Transmission may go into a default gear
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonOpen or broken wire in the shift module data line circuit
- CommonFailed gear shift (shifter) module
- PossibleWire shorted to another power circuit
- PossiblePoor ground or loose connector
- PossibleFaulty control module (rare)
Typical repair once the cause is confirmed
Repair the open or shorted wire or bad connector; if the wiring is good, replace the shift module data line.
Common questions
What does P0862 mean?
The computer sees a signal or voltage in the gear shift module communication circuit circuit that is higher than it should be. The shift module data line carries messages between the shifter module and the transmission computer.
Can I drive with code P0862?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P0862?
Common possibilities to test include: open or broken wire in the shift module data line circuit; failed gear shift (shifter) module; wire shorted to another power circuit; poor ground or loose connector. A shop should confirm the cause before replacing parts.