P0863 TCM Communication Circuit
What it means
The computer found an electrical problem in the circuit for the transmission computer (TCM) communication circuit, which carries data between the transmission computer and the other modules.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Look over the wiring and connector at the TCM data line for damage, rubbing or corrosion
- Check related fuses, power and ground with a meter
- Test the TCM data line against the factory specification before replacing it
Signs you may notice
- Check engine light on
- Transmission may be in limp mode or shift harshly
- Other modules may also store communication codes
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailed transmission control module
- PossibleLow battery voltage or poor ground
- CommonBroken or damaged wiring to the TCM data line
- CommonLoose, corroded or water-damaged connector
- PossibleBlown fuse or missing power or ground
- PossibleFaulty transmission or engine computer (rare)
Typical repair once the cause is confirmed
Repair any wiring or connector fault found; if the circuit tests good, replace the TCM data line.
Common questions
What does P0863 mean?
The computer found an electrical problem in the circuit for the transmission computer (TCM) communication circuit, which carries data between the transmission computer and the other modules.
Can I drive with code P0863?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P0863?
Common possibilities to test include: failed transmission control module; low battery voltage or poor ground; broken or damaged wiring to the tcm data line; loose, corroded or water-damaged connector. A shop should confirm the cause before replacing parts.