P0864 TCM Communication Circuit Range/Performance
What it means
The transmission computer (TCM) communication circuit is giving readings that don't match what the computer expects for the current conditions. The TCM data line carries data between the transmission computer and the other modules.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Compare the TCM data line reading with what it should be on a scan tool
- Inspect the wiring and connector for corrosion or damage
Signs you may notice
- Check engine light on
- Transmission may be in limp mode or shift harshly
- Other modules may also store communication codes
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailing transmission control module
- PossibleLow battery voltage or poor ground
- PossibleHigh resistance in the wiring or connector
- PossibleControl module software needs an update
Typical repair once the cause is confirmed
Correct any fluid or wiring problem first; if the readings are still wrong, replace the TCM data line.
Common questions
What does P0864 mean?
The transmission computer (TCM) communication circuit is giving readings that don't match what the computer expects for the current conditions. The TCM data line carries data between the transmission computer and the other modules.
Can I drive with code P0864?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P0864?
Common possibilities to test include: failing transmission control module; low battery voltage or poor ground; high resistance in the wiring or connector; control module software needs an update. A shop should confirm the cause before replacing parts.