P0865 TCM Communication Circuit Low
What it means
The computer sees a signal or voltage in the transmission computer (TCM) communication circuit circuit that is lower than it should be. The TCM data line carries data between the transmission computer and the other modules.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the TCM data line wiring for chafed spots touching metal
- Check the circuit for a short to ground with a meter
- Unplug the TCM data line and see whether the reading changes
Signs you may notice
- Check engine light on
- Transmission may be in limp mode or shift harshly
- Other modules may also store communication codes
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonWire shorted to ground in the TCM data line circuit
- PossibleLow battery voltage or poor ground
- CommonFailed transmission control module (internal short)
- PossibleCorroded or water-damaged connector
- PossibleFaulty control module (rare)
Typical repair once the cause is confirmed
Fix any shorted or damaged wiring; if the wiring is good, replace the TCM data line.
Common questions
What does P0865 mean?
The computer sees a signal or voltage in the transmission computer (TCM) communication circuit circuit that is lower than it should be. The TCM data line carries data between the transmission computer and the other modules.
Can I drive with code P0865?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P0865?
Common possibilities to test include: wire shorted to ground in the tcm data line circuit; low battery voltage or poor ground; failed transmission control module (internal short); corroded or water-damaged connector. A shop should confirm the cause before replacing parts.