P0866 TCM Communication Circuit High
What it means
The computer sees a signal or voltage in the transmission computer (TCM) communication circuit circuit that is higher than it should be. The TCM data line carries data between the transmission computer and the other modules.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check the connector for pushed-out or loose pins
- Check the TCM data line circuit for an open wire or a short to voltage
- Test the TCM data line against the factory specification
Signs you may notice
- Check engine light on
- Transmission may be in limp mode or shift harshly
- Other modules may also store communication codes
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonOpen or broken wire in the TCM data line circuit
- PossibleLow battery voltage or poor ground
- CommonFailed transmission control module
- PossibleWire shorted to another power circuit
- PossiblePoor ground or loose connector
- PossibleFaulty control module (rare)
Typical repair once the cause is confirmed
Repair the open or shorted wire or bad connector; if the wiring is good, replace the TCM data line.
Common questions
What does P0866 mean?
The computer sees a signal or voltage in the transmission computer (TCM) communication circuit circuit that is higher than it should be. The TCM data line carries data between the transmission computer and the other modules.
Can I drive with code P0866?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P0866?
Common possibilities to test include: open or broken wire in the tcm data line circuit; low battery voltage or poor ground; failed transmission control module; wire shorted to another power circuit. A shop should confirm the cause before replacing parts.