P0872 Transmission Fluid Pressure Sensor/Switch C Circuit Low
What it means
The computer sees a signal or voltage in the transmission fluid pressure sensor/switch C circuit that is lower than it should be. The pressure sensor/switch reports hydraulic pressure (or on some transmissions, the selected gear range) to the transmission computer.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Inspect the pressure sensor/switch wiring for chafed spots touching metal
- Check the circuit for a short to ground with a meter
- Unplug the pressure sensor/switch and see whether the reading changes
Signs you may notice
- Check engine light on
- Harsh, late or erratic shifting
- Transmission may stay in one gear (limp mode)
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonWire shorted to ground in the pressure sensor/switch circuit
- CommonFailed transmission fluid pressure sensor/switch (internal short)
- PossibleCorroded or water-damaged connector
- PossibleFaulty control module (rare)
Typical repair once the cause is confirmed
Fix any shorted or damaged wiring; if the wiring is good, replace the pressure sensor/switch.
Common questions
What does P0872 mean?
The computer sees a signal or voltage in the transmission fluid pressure sensor/switch C circuit that is lower than it should be. The pressure sensor/switch reports hydraulic pressure (or on some transmissions, the selected gear range) to the transmission computer.
Can I drive with code P0872?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P0872?
Common possibilities to test include: wire shorted to ground in the pressure sensor/switch circuit; failed transmission fluid pressure sensor/switch (internal short); corroded or water-damaged connector; faulty control module (rare). A shop should confirm the cause before replacing parts.