Home › Code lookup › P0880
Powertrain code · Electrical

P0880 TCM Power Input Signal

How urgent? Get it checked in the next few days

What it means

The computer found an electrical problem in the circuit for the transmission computer (TCM) power input, which supplies the voltage the transmission computer needs to run.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Look over the wiring and connector at the TCM power feed for damage, rubbing or corrosion
  2. Check related fuses, power and ground with a meter
  3. Test the TCM power feed against the factory specification before replacing it

Signs you may notice

  • Check engine light on
  • Transmission may be stuck in one gear (limp mode)
  • Harsh shifts or no upshifts

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailed transmission control module
  • CommonWeak battery, bad battery terminals or charging problem
  • CommonBroken or damaged wiring to the TCM power feed
  • CommonLoose, corroded or water-damaged connector
  • PossibleBlown fuse or missing power or ground
  • PossibleFaulty transmission or engine computer (rare)

Typical repair once the cause is confirmed

Repair any wiring or connector fault found; if the circuit tests good, replace the TCM power feed.

Repair costInsufficient verified pricing for this vehicle and repair
Walk through it step by step: Transmission warning light on →

Common questions

What does P0880 mean?

The computer found an electrical problem in the circuit for the transmission computer (TCM) power input, which supplies the voltage the transmission computer needs to run.

Can I drive with code P0880?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0880?

Common possibilities to test include: failed transmission control module; weak battery, bad battery terminals or charging problem; broken or damaged wiring to the tcm power feed; loose, corroded or water-damaged connector. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.