Home › Code lookup › P0883
Powertrain code · Electrical

P0883 TCM Power Input Signal High

How urgent? Get it checked in the next few days

What it means

The computer sees a signal or voltage in the transmission computer (TCM) power input circuit that is higher than it should be. The TCM power feed supplies the voltage the transmission computer needs to run.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Check the connector for pushed-out or loose pins
  2. Check the TCM power feed circuit for an open wire or a short to voltage
  3. Test the TCM power feed against the factory specification

Signs you may notice

  • Check engine light on
  • Transmission may be stuck in one gear (limp mode)
  • Harsh shifts or no upshifts

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonOpen or broken wire in the TCM power feed circuit
  • CommonWeak battery, bad battery terminals or charging problem
  • CommonFailed transmission control module
  • PossibleWire shorted to another power circuit
  • PossiblePoor ground or loose connector
  • PossibleFaulty control module (rare)

Typical repair once the cause is confirmed

Repair the open or shorted wire or bad connector; if the wiring is good, replace the TCM power feed.

Repair costInsufficient verified pricing for this vehicle and repair
Walk through it step by step: Transmission warning light on →

Common questions

What does P0883 mean?

The computer sees a signal or voltage in the transmission computer (TCM) power input circuit that is higher than it should be. The TCM power feed supplies the voltage the transmission computer needs to run.

Can I drive with code P0883?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0883?

Common possibilities to test include: open or broken wire in the tcm power feed circuit; weak battery, bad battery terminals or charging problem; failed transmission control module; wire shorted to another power circuit. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.