Home › Code lookup › P0886
Powertrain code · Electrical

P0886 TCM Power Relay Control Circuit Low

How urgent? Get it checked in the next few days

What it means

The computer sees a signal or voltage in the transmission computer (TCM) power relay control circuit circuit that is lower than it should be. The TCM power relay switches main power on to the transmission computer.

Can I keep driving?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Inspect the TCM power relay wiring for chafed spots touching metal
  2. Check the circuit for a short to ground with a meter
  3. Unplug the TCM power relay and see whether the reading changes

Signs you may notice

  • Check engine light on
  • Transmission may be stuck in one gear (limp mode)
  • No shifting or harsh shifting

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonWire shorted to ground in the TCM power relay circuit
  • CommonFailed TCM power relay (internal short)
  • PossibleCorroded or water-damaged connector
  • PossibleFaulty control module (rare)

Typical repair once the cause is confirmed

Fix any shorted or damaged wiring; if the wiring is good, replace the TCM power relay.

Repair costInsufficient verified pricing for this vehicle and repair
Replace TCM power relay. Prepare an itemized shop request.

Common questions

What does P0886 mean?

The computer sees a signal or voltage in the transmission computer (TCM) power relay control circuit circuit that is lower than it should be. The TCM power relay switches main power on to the transmission computer.

Can I drive with code P0886?

If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.

What causes P0886?

Common possibilities to test include: wire shorted to ground in the tcm power relay circuit; failed tcm power relay (internal short); corroded or water-damaged connector; faulty control module (rare). A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.