P0889 TCM Power Relay Sense Circuit Range/Performance
What it means
The transmission computer (TCM) power relay sense circuit is giving readings that don't match what the computer expects for the current conditions. The TCM power relay lets the transmission computer confirm its power relay has switched on.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Compare the TCM power relay reading with what it should be on a scan tool
- Inspect the wiring and connector for corrosion or damage
Signs you may notice
- Check engine light on
- Transmission may be stuck in one gear (limp mode)
- No shifting or harsh shifting
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonFailing TCM power relay
- PossibleWeak battery or charging problem
- PossibleHigh resistance in the wiring or connector
- PossibleControl module software needs an update
Typical repair once the cause is confirmed
Correct any fluid or wiring problem first; if the readings are still wrong, replace the TCM power relay.
Common questions
What does P0889 mean?
The transmission computer (TCM) power relay sense circuit is giving readings that don't match what the computer expects for the current conditions. The TCM power relay lets the transmission computer confirm its power relay has switched on.
Can I drive with code P0889?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P0889?
Common possibilities to test include: failing tcm power relay; weak battery or charging problem; high resistance in the wiring or connector; control module software needs an update. A shop should confirm the cause before replacing parts.