P0891 TCM Power Relay Sense Circuit High
What it means
The computer sees a signal or voltage in the transmission computer (TCM) power relay sense circuit circuit that is higher than it should be. The TCM power relay lets the transmission computer confirm its power relay has switched on.
Can I keep driving?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What to test before replacing parts
A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.
- Check the connector for pushed-out or loose pins
- Check the TCM power relay circuit for an open wire or a short to voltage
- Test the TCM power relay against the factory specification
Signs you may notice
- Check engine light on
- Transmission may be stuck in one gear (limp mode)
- No shifting or harsh shifting
Possible causes
Most likely first. Directions for testing, not confirmed failures.
- CommonOpen or broken wire in the TCM power relay circuit
- PossibleWeak battery or charging problem
- CommonFailed TCM power relay
- PossibleWire shorted to another power circuit
- PossiblePoor ground or loose connector
- PossibleFaulty control module (rare)
Typical repair once the cause is confirmed
Repair the open or shorted wire or bad connector; if the wiring is good, replace the TCM power relay.
Common questions
What does P0891 mean?
The computer sees a signal or voltage in the transmission computer (TCM) power relay sense circuit circuit that is higher than it should be. The TCM power relay lets the transmission computer confirm its power relay has switched on.
Can I drive with code P0891?
If the check engine light flashes, the engine runs rough, overheats, loses power or stalls, pull over when it is safe and get help. Otherwise get it checked in the next few days and drive gently until then.
What causes P0891?
Common possibilities to test include: open or broken wire in the tcm power relay circuit; weak battery or charging problem; failed tcm power relay; wire shorted to another power circuit. A shop should confirm the cause before replacing parts.