Home › Code lookup › P2017
Powertrain code · Fuel and air

P2017 Intake Manifold Runner Position Sensor/Switch Circuit High Bank 1

How urgent? Book a check when convenient

What it means

The signal from the intake manifold runner position sensor on bank 1 is higher than the computer expects. This sensor tells the computer where the intake flaps are. An open (broken) wire, a bad ground or a failed sensor is the usual reason.

Can I keep driving?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What to test before replacing parts

A shop should confirm the fault with a scan tool and a few tests before replacing parts. The code points to where to test, not to a confirmed failed part.

  1. Make sure the runner position sensor connector is fully plugged in and clean
  2. Check the sensor ground and signal wire for an open circuit

Signs you may notice

  • Check engine light on
  • Slightly weaker power at some engine speeds

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonOpen or broken signal or ground wire
  • CommonUnplugged or corroded connector
  • PossibleFailed runner position sensor (often part of the actuator)
  • PossibleWire shorted to a power source

Typical repair once the cause is confirmed

Repair any damaged wiring or connector first; if the circuit tests good, replace the runner position sensor (often part of the actuator).

Repair costInsufficient verified pricing for this vehicle and repair
Replace intake runner position sensor or actuator. Prepare an itemized shop request.

Known on these vehicles

Common questions

What does P2017 mean?

The signal from the intake manifold runner position sensor on bank 1 is higher than the computer expects. This sensor tells the computer where the intake flaps are. An open (broken) wire, a bad ground or a failed sensor is the usual reason.

Can I drive with code P2017?

Usually you can keep driving while you book a check. If other warning lights come on, or the car starts running or shifting differently, get it checked sooner.

What causes P2017?

Common possibilities to test include: open or broken signal or ground wire; unplugged or corroded connector; failed runner position sensor (often part of the actuator); wire shorted to a power source. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.