Home › Code lookup › P2135
Powertrain code · Speed and idle control

P2135 Throttle/Pedal Position Sensor/Switch A/B Voltage Correlation

How urgent? Get it checked in the next few days

What it means

Two position sensors that should agree with each other (sensors A and B) are giving different readings. On most cars these are the two sensors inside the throttle body.

Can I keep driving?

Use care. The two throttle sensor signals disagree, so the computer usually cuts power. If the car barely accelerates, stalls or idles rough, don't drive it in traffic; have it towed. If it runs normally, go straight to a shop soon.

What to test before replacing parts

Compare both throttle position signals on a scanner as the throttle moves, check the connector and wiring for corrosion or damage, and inspect the throttle body before replacing it.

  1. Inspect the throttle body and pedal connectors for corrosion or loose pins
  2. Watch both sensor readings together in live data while moving the throttle or pedal
  3. Wiggle the harness while watching for dropouts

Signs you may notice

  • Check engine light on
  • Reduced engine power or limp mode
  • Poor or no response to the gas pedal
  • Rough idle or stalling

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonFailing electronic throttle body
  • CommonThrottle sensor wiring or connector problem
  • CommonCarbon buildup on the throttle
  • PossibleShared 5-volt reference circuit shorted by another sensor
  • PossibleEngine computer problem (rare)

Typical repair once the cause is confirmed

Repair wiring or connector problems; otherwise replace the throttle body or pedal assembly, whichever holds the two sensors.

Repair costInsufficient verified pricing for this vehicle and repair
Replace electronic throttle body. Prepare an itemized shop request.

Known on these vehicles

Walk through it step by step: Reduced engine power / limp mode →

Common questions

What does P2135 mean?

Two position sensors that should agree with each other (sensors A and B) are giving different readings. On most cars these are the two sensors inside the throttle body.

Can I drive with code P2135?

Use care. The two throttle sensor signals disagree, so the computer usually cuts power. If the car barely accelerates, stalls or idles rough, don't drive it in traffic; have it towed. If it runs normally, go straight to a shop soon.

What causes P2135?

Common possibilities to test include: failing electronic throttle body; throttle sensor wiring or connector problem; carbon buildup on the throttle; shared 5-volt reference circuit shorted by another sensor. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.