Home › Code lookup › P0113
Powertrain code · Fuel and air

P0113 Intake Air Temperature Sensor 1 Circuit High (Bank 1)

How urgent? Book a check when convenient

What it means

The intake air temperature sensor is reporting an impossibly cold reading. Most often the sensor is unplugged, a wire is broken, or the sensor has failed.

Can I keep driving?

Usually you can keep driving and schedule a repair. The car may start harder in cold weather or use a bit more fuel. If it starts running rough, hesitating or stalling, or other codes show up, get it checked sooner.

What to test before replacing parts

Compare the intake air temperature reading to outside air on a cold engine, and check the connector and wiring for opens or shorts. The sensor may be built into the MAF.

  1. Make sure the sensor is plugged in, especially after an air filter change
  2. Read the live temperature; a reading near minus 40 points to an open circuit
  3. Check the wiring and connector for damage or corrosion

Signs you may notice

  • Check engine light on
  • Usually little change in drivability
  • Possible rough running or lower fuel economy

Possible causes

Most likely first. Directions for testing, not confirmed failures.

  • CommonSensor or MAF connector left unplugged or loose
  • CommonFailed intake air temperature sensor
  • PossibleBroken signal or ground wire
  • PossibleCorroded connector pins

Typical repair once the cause is confirmed

Plug in or repair the connector or wiring; replace the sensor if it reads wrong with good wiring.

Repair costInsufficient verified pricing for this vehicle and repair
Replace intake air temperature sensor. Prepare an itemized shop request.

Where it shows up

  • Often appears right after an air filter change when the sensor or MAF plug is left loose
Walk through it step by step: Check engine light on →

Common questions

What does P0113 mean?

The intake air temperature sensor is reporting an impossibly cold reading. Most often the sensor is unplugged, a wire is broken, or the sensor has failed.

Can I drive with code P0113?

Usually you can keep driving and schedule a repair. The car may start harder in cold weather or use a bit more fuel. If it starts running rough, hesitating or stalling, or other codes show up, get it checked sooner.

What causes P0113?

Common possibilities to test include: sensor or maf connector left unplugged or loose; failed intake air temperature sensor; broken signal or ground wire; corroded connector pins. A shop should confirm the cause before replacing parts.

Related codes

Trouble codes point to where a problem was detected, not always to the failed part. A scan and a few tests confirm the cause before parts are replaced. This is a general guide, not a diagnosis.